Subject: sparking to the rotor
From: Rotary Engine
Date: 1/28/2011, 10:26 PM
To: AAA Put this in the To box


With regards to sparking to the rotor; this is not good. The
current  then  needs to find a path to continue to ground. It may
try through the  seals or  through the bearings. That has the
potential to cause all sorts of nasty  things to go wrong in the
engine. Metal erosion or welding which  would be like  galling from
lack of lube.

  Dale Davies

  Dale, I agree with you. Grounding through the rotor would either jump
  the gap of the eccentric to rotor bearing or one of the gas seals.
  Anyone who ever checked a 12 volt battery with a piece of wire can
  extrapolate what 50,000 volts would do. There is of course the
  possibility that the ground would occur back to the rotor housing near
  the plasma emmiter electrode which is much closer than the rotor
  depression. The resulting damage would then take out the seals. If
it  was restrained to grounding back to it's own case like a spark
plug that  might work.

  Personally I am waiting for Ford to get their laser ignition in
  production. I would try it in the end housings angled to contact
the  side of the rotor depression and reflect back off that. I
haven't got a  clue how fast you can turn the laser on and off but
would lean toward  leaving it on and using something solid state to
enable or disable the  discharge orifice. I don't know how much
energy it would take to keep it  lit for 40 degrees of rotation
compared to the improvement in BSFC but  having 3 inches of contact
with the mixture should allow much later  timing and result in lower
compression pumping losses.

  george grimes

Guys, interesting that Volkswagen has been sparking to the piston
with no ill effect for several years. I'm not sure if it has been
released to the public yet, but they say it has advantages and no
problems with the discharges. Bill Jepson



What is the ground path? Is it the piston skirt, the rings or the rod bearing
and then to the main bearing? I know there is a lot of new technology out
there, but a lot to be looking over the shoulder at too. Remember the big push
to margarine as it was better for you. Turns out butter was not as bad as the
solution/replacement.

The Ford laser ignition sounds interesting and viable to me.

Dale Davies


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.