With regards to sparking to the rotor; this is not good. The current
then
needs to find a path to continue to ground. It may try through the
seals or
through the bearings. That has the potential to cause all sorts of
nasty
things to go wrong in the engine. Metal erosion or welding which
would be like
galling from lack of lube.
Dale Davies
Dale, I agree with you. Grounding through the rotor would either jump
the gap of the eccentric to rotor bearing or one of the gas seals.
Anyone who ever checked a 12 volt battery with a piece of wire can
extrapolate what 50,000 volts would do. There is of course the
possibility that the ground would occur back to the rotor housing near
the plasma emmiter electrode which is much closer than the rotor
depression. The resulting damage would then take out the seals. If it
was restrained to grounding back to it's own case like a spark plug
that
might work.
Personally I am waiting for Ford to get their laser ignition in
production. I would try it in the end housings angled to contact the
side of the rotor depression and reflect back off that. I haven't got a
clue how fast you can turn the laser on and off but would lean toward
leaving it on and using something solid state to enable or disable the
discharge orifice. I don't know how much energy it would take to
keep it
lit for 40 degrees of rotation compared to the improvement in BSFC but
having 3 inches of contact with the mixture should allow much later
timing and result in lower compression pumping losses.
george grimes
Guys, interesting that Volkswagen has been sparking to the piston with
no ill effect for several years. I'm not sure if it has been released to
the public yet, but they say it has advantages and no problems with the
discharges.
Bill Jepson
Bill, If VW used a waste spark type coil with both electrodes on the
same piston there would be no circuit to the cylinder or rod bearing
just back out the second electrode. I suppose that would be two
sparks at
the same time, a quicker burn, and make the limited ignition advance
dictated by the piston being near TDC before a spark can occur
workable. I wish them well. At least they are trying.
george grimes
George, I worked for Kawasaki and motorcycles were among the first users
of "floating secondary" coils. Then VW system was NOT a twin lead
system. In fact there is an extended protruding cone on the top of the
piston to receive the spark. They didn't seem to have any trouble with
the ground path.
Bill Jepson
The piston spends a long time near to dead center but a cone
on a rotor would soon move away from the spark plug.
Now a long ridge might work. The voltage on the spark plug will
determine how long before top dead center the plug fires.
As the piston gets closer to top dead center the gap gets less
of course. Same for the rotor with ridge. Of course the
ridge must be in the rotor depression cavity.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.