Subject: run on hydrogen with water injection
From: Rotary Engine
Date: 1/29/2011, 8:28 PM
To: AAA Put this in the To box


Chris,

I do believe that he was able to run it on 10% hydrogen, but the last
part, that it will dissassociate the atoms in the
molecule....na....water is the low energy point.

When you burn hydrogen/oxygen, it goes from gas to water, not the other
way around. If you put water in the flame, you will not break it
up, you  will produce steam, that in itself you may get some work
out of...we did  that for a hundred years.

So if you have gasses, like in this example, oxygen and hydrogen, the
atoms combine, and thus release energy, ...that you can use in....like
running an engine.....and with a little bit of luck, steam up the rest
of the mix, and get an additional steam push.

It takes more energy to separate hydrogen and oxygen, than what
you will  get in return in a combustion, so a fire that would
dislocate the joints  so to say between oxygen and hydrogen, would
consume the energy out of  the flame.

It just don't work that way, the fire, the bang or the flash, is where
the hydrogen and oxygen meet, not dislocate.

You can see it this way, water is the ashes of the fire between hydrogen
and oxygen, the dead and inert state after combustion.

(Go to YouTube and watch Monty Python scetch...The Dead Parrot)

A very easy experiment you can do that will give the whole cycle of
energy, from creation of hydrogen/oxygen, to energy needed to
create it,  to consume hydrogen/oxygen, and energy given back is an
experiment that  is easily set up.

The only hard part is getting a wire that is platinum coated ( almost
the only metal that acts well as a cathalyst for hydrogen)

Ok assuming you go through the hardship of getting a platinum
coated  wire,  then get  two small crocodile clips, 9V battery,  get
a glass of  water, get a tounge depressor, and a pencil.

Cut two pieces of wire, about a foot long each.

Wind up almost all the wire around the pencil, do the same with the
other wire.

Put the tounge depressor across the glass of water, and with the small
crocodile clips, put the two coiled wires down in the water so
they are  both hanging from the tounge depressor into the water..

You may, just to make the water more conductive use some weak acid,
 (  squeeze an orange )

Ok, you have now made a hydrogen cell that you can reverse at will,
either consume or create hydrogen/oxygen, exactly like the big
guys have  in the electric cars, that you are pumping hydrogen into,
and are run on  electric motors.

It's not more high tech than this.

Ok, put your 9V battery across the two wires that are sitting like
a  spiral down in the water, hold it there for a while, and you will
see  that both coils will start creating bubbles, about twice on one
coil,  that is the hydrogen side. You can take off the battery
before the coils  will start to release bubbles, , about when the
coils looks like a  Christmas tree full of bubbles, thats a good point.

Ok, ( now, battery off) now put a voltmeter across, and you will have
voltage, this is now an electric cell, and it is giving out
electricity,  as long as you have oxygen and hydrogen attached to
the coils, the gas  bubbles will be giving out electricity as the
gasses are consumed, there  will be less and less gas on the coils,
 they seem to magically  dissapear, they are now actually reversing
to water, ( from a high  energy state to a lower energy state) and
are giving energy in the form  of electricity while they are doing it.

Once all the bubbles are gone, the cell is flat.

....so basically, when the elements are combining, there is where you
find the energy "give away extravaganza", either combining quick
as a  flash in a combustion, or combining slower as
electricity....you will  not get it when they split....when they
split, you have to pay the  piper. (Please don't mix this up with
splitting atoms, Quantum Mechanics  works with their own set of laws,
 we are only talking about energy  states of molecular bonding of
atoms here)

You can measure with this set up very easy, pretty much with ordinary
multimeters...energy in...energy out...and you will find that you will
always come up shorter on the energy out part.

The only hard part in this experiment is that platinum,  the experiment
will almost certainly fail with out that metal as a cathalyst.

It will however give full clarity of the whole cycle, the energy
flow,  and the energy imbalance between creation and return,
...(plus it is  pretty fun to do it also)

Once you have done it, and seen it yourself, you can have your own
opinion about the professors claim about splitting water with a
hydrogen/oxygen combustion....that will split the water into hydrogen
and oxygen that you can burn,.... so you can split more hydrogen
and  oxygen that can burn, so you can split more.......

If the professor is right, I don't want to be on this planet when
he  starts his next experiment, he will start a chemical chain
reaction,  where he will put fire to all the oceans....with a bang.

Roger

Hi, H2 has a very wide flammability range. If I recall correctly it
is 5% to 95% in air hence its use with some fuels to get them lit
off more rapidly, methane for example. Sir Harry Ricardo found that
you could double the lean limit of gasoline with the addition of 5%
H2.  That was during WW I tank engine development.  I don't see any
problem getting an engine to run on 10% H2 and H2O but how much
power did it produce?

Murry I. Rozansky


The BIG problem for the H2 push is to store it. Jay Leno had a H2 car. Went
for a 2 week holiday and had to have it towed to a fill station. The storage
tanks are large and heavy. Fuel tanks with H2O and electrolosis won't
work for
AC use either. Water being heavier than hydrocarbon fuels.

We are back to alternate plan A. Improve the IC engine. Ultra low or no lead
fuels may help with EFI and the EPA. Their noses keep getting longer.

A rotary engine that is easily built to run either gasoline or Jet
A/Diesel by
the change of rotors, the use of spark plugs or injection; along with turbo
compound and also turbo normalizing is the way to go. Up to five rotors
to be
able to replace gas turbines to 2,000HP with a better fuel burn and similar
TBO's. The extra power plant weight is offset by reduced fuel requirement at
takeoff. Now I probably stepped in it!  :-)))

Dale Davies

Hey guys we are not about to run on hydrogen so can you go
someplace else with this thread?

We got to keep the band width focused on the practical. I get
complaints.

Paul Lamar

Post the complaints, ...unless it's a blogsite for a good ol boy club,
that call each other and make the rules.
I think the issue of hydrogen and combustion engines is appropriate,
very appropriate, and while it may not be in the line of thinking of
what owners of rotaries will do for most people, it might very well be a
possible way for others. As far as I am concerned,  I can drop it, I can
live with it as well as not.

My objection is, if there is any believers in the constitution, that the
accusation has to be put forward, and be faced by both parties.

The hydrogen was an issue that gave good and interesting response from a
lot of people.

A call in, ...like the 1-800 anonymous snitch lines painted on on
trucks,.... and get a change in venue because of that....oh well....

I'll be back on this blog when I get going seriously on my 555 system.

Until then,,,happy rotation.

Roger


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.