I finished wiring the top of the engine
with the RX8 coils mounted on the heat sink.
Here is what it looks like.
What do you think? Anything you don't like
about it? any suggestions.
I am awaiting some parts for the final steps.
Connecting the EC2 and PCM.
Paul Lamar
Paul,
If this was destined for an airplane I wouldn't mount the coil pack on
the engine. Or, it would be mounted on shock absorbers. I just
replaced my oil filter adapter which had cracked and started leaking.
It was mounted on the engine. Needless to say, I didn't mount the new
one on the engine.
Mark S in Texas
Wow that is a new one. I think you were unlucky and got a oil
filter adapter resonant frequency. Do you have a picture?
I can move the coils down to a motor mount tube. Not on this motor
mount as this is just a test stand. This is where the coils are
mounted on the stock RX8 engine. Different bracket however.
Since they are potted I don't think the coil will fail from
vibration. It is a possibility the bracket will fail but
this one is plenty stiff. That should not cause the engine to
stop as there should be a crack long before the entire bracket
and heat sink fall off. And then it will probably hang by
the wires.
I'll give it the resonant test when I get it running.
The trick is to put your fingers on it as the engine
is revving in the cruise RPM range on the ground.
You can feel things resonating.
The aero space way is to instrument everything with
miniature accelerometers or use a shake table.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.