I finished wiring the top of the engine
with the RX8 coils mounted on the heat sink.
Here is what it looks like.
What do you think? Anything you don't like
about it? any suggestions.
I am awaiting some parts for the final steps.
Connecting the EC2 and PCM.
Paul Lamar
Hey Paul,
The wiring looks sweet!
Those two black, ground?, leads that pass by pretty close to each end of
the buss bar with all the red wires attached. Are those wires
restrained? It's hard to tell from the pictures. It might not be
pretty if the insulation wore through and they shorted.
Same question on those two red wires on the lower right of pictures
three and four.
The hose on the radiator overflow is not secured to the hose barb. You
don't want that to pop off in flight and potentially spew hot coolant
all over your pretty wires.
Is that black hose the fuel supply run through the firewall along with
the yellow line that connects to the inlet plenum? The hose is laying
unrestrained on top of the water pump adapter block. Another potential
wear through point that can only result in bad things happening.
What's with the little black rubber dicky with the radiator drain valve
on one end? You've got a spring type hose clamp on one end and a screw
type hose clamp on the other. It looks like you still have the pipe
thread on the base of the valve. Putting a hose on threads is a bad
practice that almost always leads to a leak. Maybe this is just a test
fitting to be removed after setup is complete?
All the hose clamps look to be the standard issue type, not the type
with a couple of belleville washers under the screw head to maintain
constant clamping pressure when the hose barbs expand and contract under
temperature changes.
Why do you have the inlet air filter back against the firewall? Isn't
it better to have it up near the front of the plane where you can feed
cool outside air to the intake? Maybe that's dealt with when the rest
of the cowling is installed.
Mark LaPierre
This is not a flight engine. Test stand only. I am trying to
get it running. It had one or two wiring problems and one or
more dead RX8 coils. I'll deal with the plumbing issues later.
I am still thinking about those two red wires. One is 12V supply for
the injectors and coils. The larger of the two. It has a dedicated
fuse. The smaller wire is the alternator field supply wire also fused.
If they are combined into one and the alternator field shorts the
engine stops. :(
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.