Subject: Coils and injectors fully wired.
From: Rotary Engine
Date: 1/31/2011, 10:48 PM
To: AAA Put this in the To box



 I finished wiring the top of the engine
 with the RX8 coils mounted on the heat sink.
 Here is what it looks like.

 What do you think? Anything you don't like
 about it? any suggestions.

 I am awaiting some parts for the final steps.
 Connecting the EC2 and PCM.

 Paul Lamar


 Hey Paul,

 The wiring looks sweet!

 Those two black, ground?, leads that pass by pretty close to each end of
 the buss bar with all the red wires attached. Are those wires
 restrained? It's hard to tell from the pictures. It might not be
 pretty if the insulation wore through and they shorted.

 Same question on those two red wires on the lower right of pictures
 three and four.

 The hose on the radiator overflow is not secured to the hose barb. You
 don't want that to pop off in flight and potentially spew hot coolant
 all over your pretty wires.

 Is that black hose the fuel supply run through the firewall along with
 the yellow line that connects to the inlet plenum? The hose is laying
 unrestrained on top of the water pump adapter block. Another potential
 wear through point that can only result in bad things happening.

 What's with the little black rubber dicky with the radiator drain valve
 on one end? You've got a spring type hose clamp on one end and a screw
 type hose clamp on the other. It looks like you still have the pipe
 thread on the base of the valve. Putting a hose on threads is a bad
 practice that almost always leads to a leak. Maybe this is just a test
 fitting to be removed after setup is complete?

 All the hose clamps look to be the standard issue type, not the type
 with a couple of belleville washers under the screw head to maintain
 constant clamping pressure when the hose barbs expand and contract under
 temperature changes.

 Why do you have the inlet air filter back against the firewall? Isn't
 it better to have it up near the front of the plane where you can feed
 cool outside air to the intake? Maybe that's dealt with when the rest
 of the cowling is installed.

 Mark LaPierre

 This is not a flight engine. Test stand only. I am trying to
 get it running. It had one or two wiring problems and one or
 more dead RX8 coils. I'll deal with the plumbing issues later.

 I am still thinking about those two red wires. One is 12V supply for
 the injectors and coils. The larger of the two. It has a dedicated
 fuse. The smaller wire is the alternator field supply wire also fused.
 If they are combined into one and the alternator field shorts the
 engine stops. :(


 Paul Lamar


Didn't register that it was the test stand.  Duh!

 Mark LaPierre

Here is my latest invention. Does not look like much because
it isn't.

It is a little tiny PC board about .75 inch wide and 1.8 inches long.
Read very very cheap. It sits on the top of the RX8 coil heat sink
with a couple of 4-40 screws. It is much much smaller than the marine
bus bars I have used so far and it does the same job only better.

It feeds power and ground to the RX8 coils and allows the coil
harness wires to connect  with tiny terminal blocks. It also
has capacitors on board to filter out any electrical noise
the coils might introduce into the 12 volt supply.

This is the first iteration. There will be more I am sure.

Paul
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.