With regards to sparking to the rotor; this is not good. The current
then
needs to find a path to continue to ground. It may try through the
seals or
through the bearings. That has the potential to cause all sorts of nasty
things to go wrong in the engine. Metal erosion or welding which
would be like
galling from lack of lube.
Dale Davies
Dale, I agree with you. Grounding through the rotor would either jump
the gap of the eccentric to rotor bearing or one of the gas seals.
Anyone who ever checked a 12 volt battery with a piece of wire can
extrapolate what 50,000 volts would do. There is of course the
possibility that the ground would occur back to the rotor housing near
the plasma emmiter electrode which is much closer than the rotor
depression. The resulting damage would then take out the seals. If it
was restrained to grounding back to it's own case like a spark plug that
might work.
Personally I am waiting for Ford to get their laser ignition in
production. I would try it in the end housings angled to contact the
side of the rotor depression and reflect back off that. I haven't got a
clue how fast you can turn the laser on and off but would lean toward
leaving it on and using something solid state to enable or disable the
discharge orifice. I don't know how much energy it would take to keep it
lit for 40 degrees of rotation compared to the improvement in BSFC but
having 3 inches of contact with the mixture should allow much later
timing and result in lower compression pumping losses.
george grimes
Guys, interesting that Volkswagen has been sparking to the piston with
no ill effect for several years. I'm not sure if it has been released to
the public yet, but they say it has advantages and no problems with the
discharges.
Bill Jepson
The high pulse energy in a spark coil output pulse can obviously
vaporize metal. The question would be if the current return path was
interrupted while the current was flowing in the desired spark. This
would cause the voltage to rapidly increase across the opened connection
and cause an unwanted spark.
If, however, the connection resistance merely increased some but never
went to megohms, there would be no resulting spark and so no high energy
dissipation at the contact point.Remember, the power is current x
voltage and the energy is the duration of I x V. Sparks are fast. I
figure no spark, no problem.
My experience is that roller or ball bearings with a load on them have
a relatively low resistance between the inner and outer bearing race.
Lubricant is compressed into a very thin film at "contact" points
between the balls and race. This very thin film has a low electrical
resistance.
I imagine someone has done some detailed experimental work on this
while studying exactly how a lubricant works in a ball bearing system.
I haven't researched it, myself.
Also, wouldn't the apex seals form a good electrical connection to the
inner walls of the rotor housing? Assuming no exotic ceramic coating,
of course. How about the rotor side seals?
Craig
When first proposed I was thinking the ground path would be through
the side seals. What first made me think this was even possible is
the video at the MSD site where they show a continuous over 1" long
"spark" from the basic #6 box. The #7 system has even more energy.
The experimenters at PanaceaBOCAF whom are exploding water are
using high voltage systems. One spark plug design is a standard plug
cut so the electrode is flush with the case. The ground is then the case
body, would need high speed video to see if the spark is more than one
place on the case. Would this idea help with faster ignition? Will require
the rotor housing to be machined so the plug body is almost flush with
with the inside surface (and a longer plug).
Dan F
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.