Subject: Aluminum coolant tubing beaders
From: Rotary Engine
Date: 2/5/2011, 5:57 PM
To: AAA Put this in the To box


 It is absolutely essential that tubing beaders
 are used when attaching rubber hose to tubing.

 Here is what I use.

 http://www.holley.com/009ERL.asp

 This on-line catalog is a bit recalcitrant so don't spend
 much time on-line with it. Just download the pdf
 by clicking on save the pages.

 It is a Holley product so Summit should be selling it.
 Apparently they only sell the small ones.

 Also check out Jeff's Wiggins couplings on the bottom
 of the front page of the ACRE NL web site. These are the ultimate
 in plumbing connections. Widely used in aerospace and Formula
 1 race cars. Normally they cost over $100 for each coupling.
 Jeff is doing you a large favor at only $40 a set as he is
 a rotor head through and through :)

 http://www.youtube.com/watch?v=Xz1ic-w_gsU
 http://www.ehow.com/list_6977604_hand-beading-tools-tubing.html
 http://www.lowbucktools.com/beadform.html


 Paul Lamar

 Hi again,

 I was trying to fined the ACRE NL web site so I could find Jeff's wiggins
 couplings but could not find the web site can you tell me what the ACRE
 NL stands for.Thanks.

 Michael

 Michael,
 Read below :) Click on http://www.rotaryeng.net
 scroll down on the front page until you see this jpg.

 ACRE stands for AirCraft Rotary Engine.

 Paul Lamar

-- 
Hi,

What size beader do I need.Only the 0.5" tube OD or do I need other sizes.

Michael

You need a 2 inch OD for intake and a 1.5 inch OD for cooling
water.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.