I finished wiring the top of the engine
with the RX8 coils mounted on the heat sink.
Here is what it looks like.
What do you think? Anything you don't like about it? any suggestions.
I am awaiting some parts for the final steps.
Connecting the EC2 and PCM.
Paul Lamar
Paul,
If this was destined for an airplane I wouldn't mount the coil pack on the
engine. Or, it would be mounted on shock absorbers. I just replaced my oil
filter adapter which had cracked and started leaking.
It was mounted on the engine. Needless to say, I didn't mount the new one
on the engine.
Mark S in Texas
Wow that is a new one. I think you were unlucky and got a oil filter adapter
resonant frequency. Do you have a picture?
I can move the coils down to a motor mount tube. Not on this motor mount as
this is just a test stand. This is where the coils are mounted on the stock
RX8 engine. Different bracket however.
Since they are potted I don't think the coil will fail from vibration. It is
a possibility the bracket will fail but this one is plenty stiff. That
should not cause the engine to stop as there should be a crack long before
the entire bracket and heat sink fall off. And then it will probably hang by
the wires.
I'll give it the resonant test when I get it running.
The trick is to put your fingers on it as the engine is revving in the
cruise RPM range on the ground.
You can feel things resonating.
The aero space way is to instrument everything with miniature accelerometers
or use a shake table.
Paul Lamar
--
Paul,
Some sort of vibration resonance is a common problem with the 93-2000 FD
engines. Oil pressure senders, anything electronic mounted directly to the
engine seems to fail early. Don't ask me how I know.
I have been remotely mounting any sensors (FD oil pressure senders are
REALLY prone to this) by feeding them with hoses and they seem to last
indefinitely. So I would mount those coils somewhere else (Adel clamp the
assy to the motor mount?). I do know Mazda mounts the FD coils on top of the
engine in the 'rats nest', however........perhaps they don't fail because of
the automotive duty cycles.
Marc W.
If you can move something around with your fingers it is likely
to resonate and fail. Run the engine up to several steady RPM's
with a prop load and see if you can find something that is vibrating
to the touch.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.