Subject: Mistral Install (Was: Mistral Parts?)
From: Rotary Engine
Date: 2/8/2011, 7:23 AM
To: AAA Put this in the To box


 Bill,

 Here are the two sides of the engine with cowl off.  I am flying out
 of Camarillo, CA for my test hours, after it will be Santa Barbara.

 Best Regards,

 Steve Thomas    Via Marc Wiese

 Looking good Steve.

 Paul Lamar


Steve,

Looks good. I would like to suggest to change the intake hose to a welded
Aluminum tube. The serrations that make up that style hose cause a lot of
turbulence and thus restriction.

Dale Davies

There are two types of that kind of house. Lined and unlined.

http://www.aircraftspruce.com/catalog/appages/scat.php

AC Spruce  Quote:
==============================================
SCAT AIRCRAFT DUCTING

Aircraft Ducting "SCAT" type ducting has the same type construction as "CAT" except with the red silicon rubber impregnation. Sold by the foot.

Features: Lightweight and extremely flexible. Short sections, which are normally unusable, can be joined together to form a continuous length.

Applications: For use in conducting extremely cold or hot air where temperatures range from -65°F to +550°F. Not recommended for negative pressure applications.


SCEET AIRCRAFT DUCTING

Aircraft Ducting "SCEET" type ducting has two plies of silicone rubber impregnated fiberglass similar to SCAT except wire between plies. Sold by the foot.

Features: Highly flexible and can be easily installed around obstructions and sharp bends. Has less friction loss than similar non-lined ducting.

Applications: Ideal for use in conducting extremely cold or hot air at temperatures ranging from -80°F to +550°F, and for conveying fumes. Not recommended for applications involving liquids or highly abrasive materials, or for negative pressure applications.

========================================================
Unquote:

I recommends sewing the liner to the outer part with small safety wire
when used on the intake ducting of an engine. The liner has been known
to come loose and plug up the hose.

Both types could collapse if the air filter becomes clogged.
That is why it is not recommended for negative pressures.

There is always some pressure drop across an air filter.

Paul Lamar.
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.