Subject: 3 rotor p-port powered Lancair ES
From: Rotary Engine
Date: 2/9/2011, 6:04 PM
To: AAA Put this in the To box

 Here's a shot of the EM-2 taken today on my flight back from attending
 the LaGrange BBQ fly-in.  Altitude was 4700 msl, OAT was about 50F.
 The
 engine is just loafing at 6000 rpm (M/T electric prop was set to 2000).
 The faster I run this engine, the more it wants to go.  I can't wait to
 see what it will do when I really open it up.

 Note: Oil temp shown is pan temp.  I measure return oil temps with the
 EFIS.  Oil temp typically run 5-10* above the coolant temp.

 Mark

 That is pretty good. My C182 gets 10 MPG but I am only doing 150 MPH.
 The EGT looks a bit high. Are you leaning?

 I think the oil temp is still being affected by the heat from the
 close proximity of the exhaust manifold. I would extend the oil cooler
 duct out through the opening in the cowl and radius it. Rutan used that
 trick in one of his airplane designs. It shook around independent
 of the cowl.

 Paul Lamar.

 PS I forget to mention. If you shield the muffler it will block
 some of the air going through the cooler. A rock and a hard spot.
 IMHO the oil cooler would be better off on the other side.



 Paul,

 Did you not see my note that the oil temps shown on the EM-2 were
 measured in the oil pan?  Return temps are around 25* lower than
the pan
 temps.

 Also, your photos of my engine install are out of date.  I'm no longer
 running the tangential muffler.  I went back to the 3-into-1 exhaust
 that I used initially.  Performance picked up significantly, and EGTs
 dropped a bunch.  I'm presently gathering pieces for my next exhaust
 system.  The current exhaust has a shield between the exhaust and the
 oil cooler, and it is streamlined for enhanced airflow.

 Attached is a recent in-flight picture of my EFIS (sorry for the
 blurriness, it was a bumpy day).  Note the oil & coolant temps.  How
 much cooler do they need to be?  I had stuffed a t-shirt into the
 radiator plenum to help keep the temps above 130*.

 Mark S.


 Your right! I missed that point. I assume you mean by return temps
 oil coming out of the oil cooler is 25 F cooler. Very impressive.

 Paul Lamar

 Paul,

 And if anyone asks what amperage is required for a 3-rotor running 5100
 rpm, you can tell them it takes 7.1 amps.  I assume this would be
linear
 with RPM.

 Mark


Hi Mark What is included in the 7.1Amps - fuel pump/s, ign, inj etc
Cheers

Steve Izett

Steve,

It includes one fuel pump (#2 pump in stand-by mode), injectors, coils,
EC-2/EM-2, electric M/T prop, EFIS, nav/com, transponder, and strobes.
Keep in mind that this load will vary according to RPM.

Mark


Thanks Mark
Less than I thought, which is good news.

Steve Izett
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.