Subject: rx8 coil heat sink....
From: Rotary Engine
Date: 2/19/2011, 6:39 PM
To: AAA Put this in the To box


   Remember to make a 3 rotor version of your heat sink!

   Marc

   Good luck Marc. I would sell maybe 3 :)

   I'll be glad to do a custom but it won't be cheap :) I'd say around $200.

   Paul Lamar
   --
   Is Tony going to machine them?
   I suppose 2 2 rotors would work!
   Marc

   I don't know about Tony.
   We have not had the demand yet to ask Jeff to makes some.

   Paul Lamar

 Marc,

 Make them yourself. Use a router or die grinder to mill the reliefs in. Use a
 carbide that is for Al or plastic. These burrs have fewer but bigger cutting
 edges so they do not load up. A standard burr you would use for ferrous will
 load up in short order. You can use a piece of cold roll flat steel clamped to
 run the die grinder along to get a straight cut and consistent depth. Just be
 careful not to run the non-ferrous bit on the steel.

 Drilling and taping the bolt holes in Al is easy. Just use the correct cutting
 fluid to get nice clean threads. Not all cutting oils are great with Al.

 Dale Davies


Paul send me the STP file how many do you need?

Tony

OK will do in a few hours.

How many want RX8 coil heat sinks?

Next thing they will ask is how much?

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.