Subject: Help. I need a 1990-1919 turbo drain back hose.
From: Rotary Engine
Date: 2/21/2011, 9:24 AM
To: AAA Put this in the To box



   Does anybody have one they can sell?
   Does anybody know the part number?

   Paul Lamar


Yup, that has been a tough one for me.  Stock wouldn't fit my front
cover.  I ended up making one out of an off-the-shelf plate on the turbo
that fit a 1/2NPT that I connected to some copper tubes that I brazed
into the proper shape...
It has alway been a source of slowly leaking oil.

Sorry I don't have a stock one for you, but if you find a used turbo
core on e-bay, it will sometimes come with the oil return.
-- David Leonard

Turbo Rotary RV-6 N4VY
http://N4VY.RotaryRoster.net <http://n4vy.rotaryroster.net/>
http://RotaryRoster.net <http://rotaryroster.net/>

Thanks Dave.

---------------------------------------

I think I solved the problem.
Make it :)
Burns has .75 inch OD 16 gage 90 degree bends in 304.
Expensive but not that much. Same OD as the stock drain back.

McMaster has all steel braided hose for the flex part.
NPT ends but they can be cut off and welded.

Paul Lamar


BTW Dave I think I know why your drain back is leaking.
The manifold expands and contracts relative to the
front cover, You need some flex in there. I don't know
what size copper you are using but McMaster
has some all steel flex that can be soldered to the
copper. It is called Braided Hose Assemblies. 12 inches long.
Too long. You need to cut off the NPT ends with a friction saw blade.

McMaster also has some 1/2 inch pipe (1 inch OD) Sch 10  bends for $3
if you want to start over and tig weld. Page 11 catalog  108


Paul Lamar



Yes, of course.  I do have a section of steel braided hose near the
cooler side.  Wrap the whole thing in several layers of aluminum foil to
prevent the oil from coking (sp?).

-- 
David Leonard

Turbo Rotary RV-6 N4VY
http://N4VY.RotaryRoster.net
http://RotaryRoster.net

Is the braid Teflon lined?

The critical area is up near the turbine housing.

Mazda made an improvement in that area after the first turbo.

Here is a picture. They added this heat shield. I am going to salvage
that shield from the one I have that does not fit the front cover.

I would think aluminum foil would melt. If it don't melt than
the temps are below 1100  F. Encouraging. I think the original
problem was they  were NOT using synthetic oil :)

I think I am going to silver solder the all steel flex on. I think the melting
temp of silver solder is much higher than soft solder.

The problem with all this is heat soak after the turbo is shut off
the cooling water is no longer flowing and the oil is no longer
flowing which also has a role. Fortunately aircraft always have
to slow for approach and to taxi after landing :)

I just bought a 90 degree bend .75 OD 304 from burns and hose
from Mcmaster so I'll find out if it all works.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.