Subject: KIS motor mount and nose gear.
From: Rotary Engine
Date: 2/23/2011, 11:24 PM
To: AAA Put this in the To box


Michael,
  I woke up with another bright idea this morning.
  I combined the nose gear bracket and the rear motor
  mount strut bracket in one part. The inertia load of
  the engine on the nose gear during a hard landing  goes
  directly into the nose gear and not through the firewall
  first. Direct load path through one bracket. Reduces the stress
  on the firewall.

  http://tinyurl.com/45o5fv4
  http://tinyurl.com/4rrpv7v

  Paul Lamar

  ---------------------------------------------------------------------------

  Every know and then some silly engineer designs something  that
  cannot be assembled. That was the case here. I had to add a front
  window so I could get a box wrench inside this thing to tighten the
  nut :)

  You might think hey..... this is no problem. Just use a deep
socket.  Well that won't work as the shock strut will turn inside
the shock body  so there needs to be a way of holding it. Normally
the typical shock  strut rod as a couple of flats above the threaded
portion. That  won't work here.

  The solution is a special Stud with a hex key pocket in the top of
  it. This is coupled to the shock rod with a double female coupling
  that can be jammed and lock tited. This is all KIS Cruiser nose
gear  design SOP.

  Good thing it did not make it to Siapan before somebody found this
  out :)

  Paul Lamar

Paul,

I am not clear on how that assembly connects to the shock. What is
the rubber rod end for? You do not want something that will be
loaded on a bolt in single shear.

Dale Davies

It is the end of a strut that holds up the back of the engine.

The max load on that half inch  bolt is 120 pounds under high thrust.

Lets see 1/2 inch bolt .196 square inches area X cheap bolt max
stress 50,000 psi = 9800 pounds max shear load.  Factor of safety in
 single shear  = 80!

Bending moment .5 inch times 120 pounds 605 inch pounds on the bolt.

http://www.engineeringcalculator.net/cross_section_properties.html

I sub x = .049

http://www.engineeringcalculator.net/beam_calculator.html

????! could it really be that low?

Of course the max load on the bolt occurs if you drop it
in from 20 feet, full thrust and 6Gs. In that case  it is 720 pounds.
A factor of safety of only 13.6 :) That should buckle your fuselage:)
Bob White crashed tested one of these motor mounts and the only part
that failed was one of  the lower tubes buckled. The BD4 fuselage
was wrinkled.

I believe in over engineering brackets as they are small and
don't add that much weight overall.
http://www.rotaryeng.net/mm-instruct.html

Paul Lamar


Photo attachment 1 explained it to me. It combines the top shock mount and the
engine mount in one.

Dale Davies


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.