Old messages.

------------------------------------------------------------------------

Paul,
      Original mount on the glastar sportsman is a 5 hole mount.

   Distance between bottom two holes  31  1/4 inches.
   Distance between two upper holes   36  3/4 inches.
   Distance between bottom holes and upper holes vertically  21  3/4 inches.
   Distance between the top outer holes and top central hole   20  1/2 inches.

existing distance from firewall and prop flange is   35 inches, but this is an Eggenfellner subaru 6 cylinder motor and quite heavy I believe. I would expect that a rotary would have to be mounted further forward for the C of G.

Thrust line as near as I can see is 3 inches below the upper outside holes.

I am hoping to use the top central mount hole for the back mount on the motor. Currently it does nothing.

Neil Unger.



 Paul,
          I  contacted Jeff with details from your web page, but he does not supply the rubber mounts.  Where can I source them?
     Also is there just a chance that you have engine mounts that fit a glastar sportsman? Perhaps drawings??  If not I can manufacture them here.
       Neil Unger.

 Check my web site again.
 I just added the McMaster Carr source for those under 10 dollar rubber bushings.  Scroll down to just below Jeff's plate on the front page of the
web site.


 If you send me the dimensions on the firewall I can do a 3D
 and the distance from firewall to prop flange
 one using Jeff's plate.

 Paul Lamar

-----------------------------------------------------------

Here they are.

Paul Lamar