I have one of Tracy's early PSRU with the roller
helical gear thrust bearing. Tracy changed it out
for multiple needle bearings. Does anybody
know whether he uses two or three needle bearings
back to back? I am in the process of upgrading it
now.
Is the motor plate counter bored?
Paul Lamar
Two, my RD-1-C purchased last year.
C. Smith
Thanks C.
Paul Lamar
Paul, If you don't want to counter bore the plate you might use a snap
ring to bottom the seal against.
george
It is counter bored from the other (back) side for the oil seal and I have no
problems with that. I just added up the double needle bearing stack
and it comes to 7 + 4 + 1 = 12 MM total. Two 3.5 mm thick washers two 2 mm
needle bearings and one 1 mm thin separator. There is marginal room between the
helical sun gear and adapter plate. As I recalled Tracy counter bored the front
of the plate for the needed clearance but I could be wrong. The sun gear
is way longer than necessary so I think I can take off one or two millimeters
in that area. Here is a picture of the early roller thrust bearing which
turned out to have inadequate life. Doubling the needle bearings halves
the RPM of each bearing greatly extending the life. Ross was the first to
come up with the idea I think. All of Tracy's boxes have this feature and it
happened a year or less after the first box was sold. It could be eleven
years now.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.