Subject: Exhaust port and Old 13B
From: Rotary Engine
Date: 3/3/2011, 2:24 PM
To: AAA Put this in the To box


Paul,

Just heard from Jeff Doddridge regarding my P-port single rotor.  My
housing is quite unusual.  Has 13B molded into the case, but the exhaust
port is about half the size of a "normal" 13b.  Also, a couple of bolts
interfere with the two inch port.  He could fit a 1 and 7/8 pipe between
them.

Wondering if you know about the design evolution of exhaust port
size. Would a smaller port increase torque?  Lou Ross estimated this
engine at 120 hp, using a static test and known propeller quantity.
He figured 120 hp at 6200 rpm.  Had regular side ports at the time.
Is he mistaken, or something about the exhaust making a difference?

Trying to get my head around intake/exhaust port relationships.  Jeff
has a regular 13b that is p-ported, and I'll probably go that way on
the rebuild.

Lewis.

You may want to get a later rotor housing as those early housings
used a low silicon aluminum alloy that had a bad habit of shrinking
when the engine was over heated.

Try to find something later than 1989 if used and of course new 13B
(not RX8) will have the right alloy. A larger port would definitely
help the HP at 6000 RPM.

Lou Ross over estimated the HP. A side port one rotar is lucky to
see 75 HP. Early 13B two rotor engines were 130 HP as I recall.

BTW over 2.5 million Mazda rotaries have been made. That has to be right
up there with VW's and small block Chevs (not counting LS series).

Paul Lamar


I thought that by the time Mazda introduced the 13B they had better alloys. I
had a 10A that had the shrunk rotor housings. Had to remove the leading plugs
and turn it over by hand to let the coolant out. Once started it would expand
and seemed OK. It finally seized a plug and I broke it trying to get it out.
As long as the width of the housing is consistent, and it does not over heat
it should be good to use. I do agree that a later housing would be better.

If Lewis wants to use this housing, bore the p-port and weld in the tube. The
bolt in that area should not be a problem. Two ways to deal with it.
1; mill counter bores and install cup plugs to keep the coolant out of the
rest of the bolt hole. No bolt installed but low pressure area.
2; drill the bolt hole out and through the steel p-port. Tig weld a sleeve
that matches the bolt OD and the ID of the hole drilled. 0.035 tube should
work. The weld will seal the sleeve to the intake port. A small counter bore
on each side of the housing machined before the tube is welded in to accept an
O-ring will keep the coolant where it is supposed to be.

Dale Davies


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.