Subject: Exhaust port and Old 13B
From: Rotary Engine
Date: 3/3/2011, 2:26 PM
To: AAA Put this in the To box


 Paul,

 Just heard from Jeff Doddridge regarding my P-port single rotor. My
 housing is quite unusual. Has 13B molded into the case, but the exhaust
 port is about half the size of a "normal" 13b. Also, a couple of bolts
 interfere with the two inch port. He could fit a 1 and 7/8 pipe between
 them.

 Wondering if you know about the design evolution of exhaust port size.
 Would a smaller port increase torque? Lou Ross estimated this engine at
 120 hp, using a static test and known propeller quantity. He figured
 120 hp at 6200 rpm. Had regular side ports at the time. Is he
 mistaken, or something about the exhaust making a difference?

 Trying to get my head around intake/exhaust port relationships. Jeff
 has a regular 13b that is p-ported, and I'll probably go that way on the
 rebuild.

 Lewis.


 You may want to get a later rotor housing as those early housings
used a low
 silicon aluminum alloy that had a bad habit of shrinking when the
engine was
 over heated.

 Try to find something later than 1989 if used and of course new 13B
(not RX8)
 will have the right alloy. A larger port would definitely help the HP
at 6000 RPM.

 Lou Ross over estimated the HP. A side port one rotor is lucky to see
75 HP.
 Early 13B two rotor engines were 130 HP as I recall.

 BTW over 2.5 million Mazda rotaries have been made. That has to be right
 up there with VW's and small block Chevs (not counting LS series).

 Paul Lamar

Thanks, Paul.
I'll go with a newer housing.

Lewis

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.