Subject: PSRU helical gear thrust bearing.
From: Rotary Engine
Date: 3/3/2011, 4:15 PM
To: AAA Put this in the To box



I have one of Tracy's early PSRU with the roller
helical gear thrust bearing. Tracy changed it out
for multiple needle bearings. Does anybody
know whether he uses two or three needle bearings
back to back? I am in the process of upgrading it
now.

Is the motor plate counter bored?


Paul Lamar

Two, my RD-1-C purchased last year.
C. Smith

Thanks C.

Paul Lamar


Paul,  If you don't want to counter bore the plate you might use a snap
ring to bottom the seal against.


george


It is counter bored from the other (back) side for the oil seal and I have no
problems with that. I just added up the double needle bearing stack
and it comes to 7 + 4 + 1 = 12 MM total. Two 3.5 mm thick washers two 2 mm
needle bearings and one 1 mm thin separator.  There is marginal room between the
helical sun gear and adapter plate.  As I recalled Tracy counter bored the front
of the plate for the needed clearance but I could be wrong. The sun gear
is way longer than necessary so I think I can take off one or two millimeters
in that area. Here is a picture of the early roller thrust bearing which
turned out to have inadequate life. Doubling the needle bearings halves
the RPM of each bearing greatly extending the life. Ross was the first to
come up with the idea I think. All of Tracy's boxes have this feature and it
happened a year or less after the first box was sold. It could be eleven
years now.

Paul Lamar

Paul, there are some spacers and stuff in the bearing stack, I can send you a
picture tomorrow if you want.
C. Smith

That would be great C. I tired calling Tracy today but I did not make it before
4PM EST. I am sure he would fix it for me but the shipping both ways would
be a lot. It is quicker and easier for me to do it.

Paul Lamar

Here they are. Sorry, I got side tracked by some other comitments. Hope this
helps.
C. Smith

Just what I was looking for C.

Thanks

Paul Lamar


Ok. Now I have a question. In my recollection, I was very careful to preserve
the orientation of all of the stack components during disassembly. My ignorance
of the engineering charecteristiscs of these pieces, does it look right to you?
Both sets of rollers are oriented the same. Does it matter face up or face down?
C. Smith

Does not matter. The cage is just easier to make asymmetrical.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.