I was in the process of rebuilding the oil supply
and turbo water cooling system on the 2nd gen Mazda turbo charger.
Cooling the turbo shaft has a large effect on the strength
of the turbine blades. See the JPG. The highest stress is at
the root of the blades attached to the shaft. If one can cool
the shaft one can strengthen the joint.
I had redesigned the intake manifold, made casting patterns in
a stereo lithography machine at the local college and had castings
made and machined. We sold out except for the one I saved for the turbo
engine
in my KIS cruiser kit. We could not use the original turbo intake manifold
as it was too high for the low KIS cowl. In fact it was not a good idea
to use it cut down as it gave a rather bad aerodynamic internal shape.
Unfortunately, or fortunately depending on how one looks at it, we lost
the
turbo cooling water connection when we redesigned the manifold. I did not
think
too much about it until recently when it became necessary to redesign the
cooling system.
I was stunned to find out the cooling water going to the turbo was already
heated by the hottest part of the engine. That reduced the cooling effect
on the
turbo. The second stunning fact was the turbo cooling water drain back
did not
go to the flow of hot water going into the rad to be cooled yet again as
one
would think. It short circuited the rad and flowed back into the input
side to
the water pump along with the cool water from the rad!!!
What the heck were the Mazda engineers thinking??? This means the heat put
into the turbo cooling water was now heating the engine cooling water
before it
got into the engine and do its job of cooling the engine???? No wonder it
was so
hard to cool the turbo engine as Dave Leonard found out. He had to use a
really
thick rad.
IMHO It would be much better to send the turbo cooling water to the rad
along
with the hot water from the engine. That would increase the temperature
of the rad increasing the heat transfer to the out side cooling air.
That would supply colder water to both the engine and the turbo.
IMHO this stock turbo cooling system is partially to blame for all the
stock
turbo failures we have seen.
What am I missing?
This also has implications for the turbo compound version that uses
a turbo charger.
Paul Lamar
Hi Paul, I think the cooled bearing housings main function is to prevent
coking after shut down. While running, the oil flow is the main bearing
coolant. The coolant plumbing is supposed to allow thermosyphon cooling
after shut down. The flow may acctually be reversed.
Murry I. Rozansky
mirco@jps.net
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.