Subject: Sorting out the plumbing morass
From: Rotary Engine
Date: 3/17/2011, 7:14 AM
To: AAA Put this in the To box

In the course of optimizing the turbo engine plumbing
I discovered that steel 37 deg JIC and AN are more or less interchangeable.

There are some very useful devices in steel JIC that are not available in AN.

Here are a few JPGs in an attempt to sort all this stuff out.

I recommend going with .035" thick wall soft steel or soft stainless steel tubing in the 3/8 and 1/2 inch sizes where every possible as it is much less likely to fatigue/crack than aluminum and it is a lot cheaper than braided hose. It is also higher temperature tolerant and a LOT LOT cheaper than Teflon lined braided hose.

AN-10 37 deg flare ID = .5 inches

AN-8  37 deg flare ID = .395  use for 1/2 inch OD steel tube.

AN-6  37 deg flare ID = .300  use for 3/8 inch OD steel tube.

Use the smooth 90 deg swivel fittings where ever fluid flow rate is high
as there will be less pressure drop through the fitting. In the case of oil
there will be a slight reduction in oil temperature as high flow through a
sharp 90 degree fitting will increase the oil temperature as much as 10
degrees F.

You will need a tube bender and a 37 deg flaring tool. Especially for the 1/2 inch steel tube. I modified a 45 deg flaring tool to save a lot of money.

Once you get used to it the connections are also simpler than braided hose and probably more reliable. JIC is used in all sorts of heavy duty hydraulic equipment subject to much shock and vibration. Support long runs with clips
to something solid even tho the rotary has much much less vibration than
a piston engine.

The downside is a slight increase in weight but we are not building airliners here with 1000's of fittings.


Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.