Paul,
I'm looking into the possibility of using the '89-'92 year 9.7:1 rotors on the
P.P test engine. Do you happen to know the redline for these rotors?
T.O. will be at 8300, but I would like the engine redline to be 9,000 which
is less than the Renesis engine I believe.
I may have to have the 9.7:1 rotors lightened a bit.
http://www.mazdatrix.com/faq/rotorwgt.htm
I was going to go with Renesis rotors for the 110 grams reduction in weight and
the slight increase in compression ratio, but to use them in a 13B engine I
would have to incorporate lots of the Renesis engine parts. E-shaft, stationary
gears, counter weights etc. The biggest issue is the durability of the stock
apex seals going over the P-ports. The Renesis rotors would have to be machined
both to accept a deeper 2mm apex seals, and fix side clearance issues
encountered when used with 13B housings.
Doug in Japan
It is the rotor bearing that is the limit. As I recall the "windowed"
version of the rotor bearing is good to 11,000 RPM with just about
all stock cast iron rotors. The RX8 rotors are just a little bit lighter.
Racing Beat uses a 3D NC mill to get a few ounces out of the stock rotors
at great expense. M V squared over R.
The 13B intake p-port, if anything, is better than 13B side input port as the
apex seals are cooled better. The worst effect on the apex seals
comes from the p-port exhaust. Not the p-port intakes. RX8 side exhaust are
easier on the apex seals. The P-port RX8 engine IMHO is the best of all worlds.
If money is no object why fool around? Go with Iannette silicon nitride
apex seals. Guaranteed to last for ever and be unbreakable.
Dave Lemon at Mazdatrix melted a steel rotor housing liner by running the engine
long after all the coolant blew out. He took the Iannette seals
out and is still running them to this day in new engines.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.