http://www.stealth316.com/2-3s-compflowmaps.htm
This is for a 3 liter Mitsubishi V6 engine which
is about right for p-port 2.6 liter Mazda 13B
due to the Mazda higher volumetric efficiency.
Plotting the engine demand line on the flow map clarifies
the
situation some what.
Paul Lamar
Paul
Is the Stealth application using 2 of these turbos? I
compared with this site
http://www.rbracing-rsr.com/turbotech.html which has a
flow calculator, and find that 300CFM(24.2#/min)flow is
equivalent to 200hp.
regards Robert
I don't know. I do not pay any attention to it.
Here is what I have on flow verses displacement.
A NA 3 liter would be about 200 CFM at 5000 RPM at 80% VE.
What you do is convert CFM to pounds of air burned
per hour and divide by 14.7.
That gives you pounds of fuel burned per hour. Then assume
the engine uses half
a pound of fuel per HP per hour. Double that number and you
will have
the HP.
200 CFM is about 30 pounds of air per minute.
30 pounds of air per minute is 1800 pounds per hour.
Divide by 14.7 and you get 122 pounds of fuel per hour.
So the HP is 245 HP roughly.
Paul Lamar
You are right. I mis read my own chart. It is right there in
black and red. HP is 122 normally aspirated.
I was looking at the 2nd chart for 10 psi boost and it is 30 pounds
per minute so the HP is 245.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.