http://www.stealth316.com/2-3s-compflowmaps.htm
This is for a 3 liter Mitsubishi V6 engine which
is about right for p-port 2.6 liter Mazda 13B
due to the Mazda higher volumetric efficiency.
Plotting the engine demand line on the flow map clarifies
the
situation some what.
Paul Lamar
Paul
Is the Stealth application using 2 of these turbos? I compared with
this site
http://www.rbracing-rsr.com/turbotech.html which has a
flow calculator, and find that 300CFM(24.2#/min)flow is equivalent
to 200hp.
regards Robert
I don't know. I do not pay any attention to it.
Here is what I have on flow verses displacement.
A NA 3 liter would be about 200 CFM at 5000 RPM at 80% VE.
What you do is convert CFM to pounds of air burned per hour and
divide by 14.7. That gives you pounds of fuel burned per hour. Then
assume the engine uses half a pound of fuel per HP per hour. Double
that number and you will have the HP.
200 CFM is about 30 pounds of air per minute.
30 pounds of air per minute is 1800 pounds per hour.
Divide by 14.7 and you get 122 pounds of fuel per hour.
So the HP is 245 HP roughly.
Paul Lamar
Don't forget the Mitsubishi is a twin turbo design.
Dale Davies
We don't know if the 300 CFM is for the whole engine or just
half the engine :)
I kind of doubt it is for half the engine. I think it is for
both turbos.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.