Subject: Interesting turbo charger web site
From: Rotary Engine
Date: 4/2/2011, 11:39 PM
To: AAA Put this in the To box


http://www.stealth316.com/2-3s-compflowmaps.htm
  This is for a 3 liter Mitsubishi V6 engine which
  is about right for  p-port 2.6 liter Mazda 13B
  due to the Mazda higher volumetric efficiency.

  Plotting the engine demand line on the flow map clarifies
  the
  situation some what.

  Paul Lamar

Paul
Is the Stealth application using 2 of these turbos? I compared with
this site http://www.rbracing-rsr.com/turbotech.html which has a
flow calculator, and find that 300CFM(24.2#/min)flow is equivalent
to 200hp.

regards Robert

I don't know. I do not pay any attention to it.

Here is what I have on flow verses displacement.
A NA 3 liter would be about 200 CFM at 5000 RPM at 80% VE.

What you do is convert CFM to pounds of air burned  per hour and
divide by 14.7. That gives you pounds of fuel burned per hour. Then
assume the engine uses half a pound of fuel per HP per hour. Double
that number and you will have the HP.

200 CFM is about 30 pounds of air per minute.
30 pounds of air per minute is 1800 pounds per hour.
Divide by 14.7 and you get 122 pounds of fuel per hour.
So the HP is 245 HP roughly.

Paul Lamar


Don't forget the Mitsubishi is a twin turbo design.

Dale Davies

We don't know if the 300 CFM is for the whole engine or just
half the engine :)

I kind of doubt it is for half the engine. I think it is for
both turbos.

Paul Lamar



Paul

Did you notice the significance of this paragraph concerning
turbocompound turbine?   If not look at the "R" and understand  the
turbine direction spins opposite of most  is reversed.  A roller drive
won't need to have the final reversing gears.  This turbine san MIGHT be
a candidate for turbocompounding experiments.

*TD05HR-16G6*. This is a new upgrade choice for the DSM cars. This turbo
is used in the Mitsubishi Lancer Evolution IV to VIII. I think this same
wheel is used in the Evo III (but cast in mirror image?), which uses a
standard TD05H-7cm^2  turbine housing. The TD05HR turbine rotates
reverse (the "R" in the designation) of the standard TD05H and has a
twin-scroll design. The compressor inducer is a little larger (0.01")
than the "big" 16G. So is this the "biggest" 16G? Max flow is better
than the 16G "large wheel". Efficiency is much better than the 16G
"large wheel". At 5000 to 8000 RPM and above, this turbo offers very
high boost levels and so very high flow levels. Real 530 cfm effective
VAF should be attainable with this compressor. A different exhaust
manifold is required for the TD05H turbine.


Cheers

Doug in Japan

That is also very interesting.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.