http://www.stealth316.com/2-3s-compflowmaps.htm
This is for a 3 liter Mitsubishi V6
engine which
is about right for p-port 2.6 liter
Mazda 13B
due to the Mazda higher volumetric
efficiency.
Plotting the engine demand line on the
flow map clarifies
the
situation some what.
Paul Lamar
Paul
Is the Stealth application using 2 of these turbos? I
compared with
this site
http://www.rbracing-rsr.com/turbotech.html which has a
flow calculator, and find that 300CFM(24.2#/min)flow is
equivalent
to 200hp.
regards Robert
I don't know. I do not pay any attention to it.
Here is what I have on flow verses displacement.
A NA 3 liter would be about 200 CFM at 5000 RPM at 80%
VE.
What you do is convert CFM to pounds of air burned per hour and
divide by 14.7. That gives you pounds of fuel burned per
hour. Then assume the engine uses half a pound of fuel per HP per
hour. Double that number and you will have the HP.
200 CFM is about 30 pounds of air per minute.
30 pounds of air per minute is 1800 pounds per hour.
Divide by 14.7 and you get 122 pounds of fuel per hour.
So the HP is 245 HP roughly.
Paul Lamar
Don't forget the Mitsubishi is a twin turbo design.
Dale Davies
We don't know if the 300 CFM is for the whole engine or
just half the engine :)
I kind of doubt it is for half the engine. I think it is
for both turbos.
Paul Lamar
Your initial flow graphs are labeled as "per turbo" . I think that
is a twin turbo Stealth.
Robert
What is the claimed total HP for the engine?
Paul Lamar
I own one of these engines. From the factory they put out about 300hp
and an equivalent number in torque, with a boost limit at about 8psi.
Waste gates begin to open at 5 psi. Not my favorite engine really, but a
hell of a lot easier to work on than an aircooled 911 engine.
Ed Carver
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.