Subject: RX-8 Manual Ring Gear and starter motor measurements
From: Rotary Engine
Date: 4/3/2011, 11:34 PM
To: AAA Put this in the To box


Does anyone have the following:-

1. The Ring gear diameter of the Manual 13b-MSP (Renesis RX-8) engine to
the bottom of the teeth
2. The Ring gear diameter of the Manual 13b-MSP (Renesis RX-8) engine to
the top of the teeth.
3. The centre of the starter motor shaft to the bottom of the gear teeth.
3. The centre of the starter motor shaft to the top of the gear teeth.

I am trying to save myself a trip over the other side of town to measure
it,  which would take
about 2 hours round trip to where it is at the moment.

I have to make sure that the drawing I am redoing has the correct
clearance for the teeth the starter motor.
and I have to correct the location of where it should be (Tracys drawing
is great for his gear-box  but being
at the bottom it will not work with the gear-box I'm using which has an
offset of 84mm downwards.
Autoflight from NZ

Regards David

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.