Hi Jean,
What scale are you making the Piaggio? Are you using two Renesis engines?
Dale Davies
Hi Dale
I am working on 55 to 60% of Piaggio and intend to use 2 rx-8 13b rotary
engine p port, i have already one engine modified with p port and 2
other engine on the ground ready to be modified.
I still working on a new drive using piston engine clevite bearings,
the propshaft will be built to use both side trust of main bearing and
hydraulic constant speed prop can be installed, i do have 2 alternative
of using the prop governor been driven by the propshaft which is very
complex or install the governor be driven by the motor with bell drive.
i am looking to save machining time and cost by incorporating the planet
housing been part of the propshaft by using the original planet gears
small shaft and been secure the same way with the small drivin pressure
pins.
Regarding the other ring i already machined some part by using the
holding ring plate and bolted to an outside plate so i can attached to
the alum housing but i will be turned the opposit way as Tracy did and
should old more oil to lubricate the planet gears
It will be split housing be machined from 2 solid rectangular alum
block 4" by 8" by 12"long each bloc cost $150.00 plus shipping.
I been delay a bit my project this winter because i was very busy
selling property to canadian snow bird who bouht lot of property with
their cdn money who worth $1.04 versus us and very low market value.
It start to slow down this month and i will spend more time on the
project this summer.
I miss the Sun and Fun show this year lack of time.
Jean Prudhomme
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.