Subject: A little bit of my muffler theory
From: Rotary Engine
Date: 4/20/2011, 1:21 PM
To: AAA Put this in the To box


Obviously noise is made when a high speed flow of hot exhaust gas
is suddenly released from the end of a pipe.

If you cool the air in the pipe some how the velocity, pressure and
volume of the air exiting the pipe will be reduced.

In effect you are taking energy out of the exhaust
gas.

Energy is also reduced by the friction between
the exhaust gas flow and the pipe wall.
Heat is transferred to the pipe wall by friction and conduction
so the energy in the exhaust gas is reduced.


The shape of the pipe outlet hole has an effect
on the frequency of the sound.

A large hole and the frequency is reduced.
A small hole and the frequency is increased.
A long rectangular hole and the frequency is increased.

I suspect that many small holes to keep the exit area the same
are better than one large hole as far as the distance the sound carries.

-------------------------------------------------------------

In theory a couple of pipes like this last jpg should work
and be completely fail safe. The frontal area is low so the
drag may be lower than it looks.
http://www.ewha.co.kr/company/eng1.htm

The ultimate solution is recover all this waste energy in the exhaust
with a turbo compound set up. Exhaust driven turbines do a good
job of quieting the exhaust. Turbo charged rotaries need no mufflers.

Paul Lamar


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.