Subject: A little bit of my muffler theory
From: Rotary Engine
Date: 4/20/2011, 3:32 PM
To: AAA Put this in the To box



Obviously noise is made when a high speed flow of hot exhaust gas
is suddenly released from the end of a pipe.

If you cool the air in the pipe some how the velocity, pressure and
volume of the air exiting the pipe will be reduced.

In effect you are taking energy out of the exhaust
gas.

Energy is also reduced by the friction between
the exhaust gas flow and the pipe wall.
Heat is transferred to the pipe wall by friction and conduction
so the energy in the exhaust gas is reduced.


The shape of the pipe outlet hole has an effect
on the frequency of the sound.

A large hole and the frequency is reduced.
A small hole and the frequency is increased.
A long rectangular hole and the frequency is increased.

I suspect that many small holes to keep the exit area the same
are better than one large hole as far as the distance the sound carries.


Paul Lamar

A few more thoughts..

- Supersonic flow dynamics

- Speed is reduced as volume is increased

For subsonic flow, the diameter of the exhaust pipe can be increased to slow the advancing flow of gas. This will also cool it through increased volume. Instead of heating the muffler components.

Increasing the diameter smoothly will allow relatively laminar flow (megaphone or departure angle). But that's not necessarily what we want. Laminar flow would be good for maintaing peak flow with low backpressure, but causing turbulence in the pipe should be good for sound reduction. So, a fairly effective method for muffling might be to step the pipe diameter up and down. Not revolutionary as that's what most conventional mufflers do already.

I think it makes sense to try to figure out what pieces of the muffler are going to get the hottest, and focus on how to make those pieces survive, either by providing direct cooling, or by building out of heavy material.

One of my ideas is to have a chamber that orients the manifold pipes onto a w shaped channel that forms the bottom of the muffler.  The w would be cooled by free stream air. The exhaust would exit from the end of the chamber.

Regardless of the configuration, consideration must be given for how the muffler is going to expand and contract given differential heating. Otherwise the system will fail from fatigue.


Matt-

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.