Subject: Off topic: aerodynamics of amphibious aircraft
From: Rotary Engine
Date: 4/20/2011, 12:01 PM
To: AAA Put this in the To box



Murry and C.,

Your points are well taken!  I was visualizing a "low-wing monoplane" where
the under surface of the wing more or less coincided with the undersurface of
the fuselage, making it a fairly flat surface.  In addition, the float
cross-section, might be "hull-shaped" on its infero-lateral surfaces, but
"flatter" on its top.  To the extent that a 'nozzle' effect is produced
between the 'flat' upper float surface and the flat under surface of the
fuselage, and flow separation is created as the aft fuselage contour changes
angle, this would be undesirable.  To the extent that the top surface of the
float is more rounded, and the bottom surface of the fuselage is rounded,
they would behave more like a bodies of revolution.  In such a case, the
nozzle effect would be minimized, and flow separation would be lessened, and
the comparison to struts would be minimal.  I also agree with you in that
the devil is in the details here.  I have attached relevant pages from
Hoerner so that C.  Smith can look these over for himself.  I note that in
figure 48 [in the attached file] that drag coefficients of pairs of bombs,
tanks, or nacelles, varies as a function of their distance of separation, so
even in bodies of revolution, interference drag can play a role.



Gene Kahn

Gene, please set your right margin to 77.
I have to load this stuff into Linux joe and reformat.

Thanks for scanning that Hoerner stuff.


Paul Lamar



-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.