Obviously noise is made when a high speed flow of hot exhaust gas is
suddenly released from the end of a pipe.
If you cool the air in the pipe some how the velocity, pressure and volume
of the air exiting the pipe will be reduced.
In effect you are taking energy out of the exhaust gas.
Energy is also reduced by the friction between the exhaust gas flow and the
pipe wall.
Heat is transferred to the pipe wall by friction and conduction so the
energy in the exhaust gas is reduced.
The shape of the pipe outlet hole has an effect on the frequency of the
sound.
A large hole and the frequency is reduced.
A small hole and the frequency is increased.
A long rectangular hole and the frequency is increased.
I suspect that many small holes to keep the exit area the same are better
than one large hole as far as the distance the sound carries.
-------------------------------------------------------------
In theory a couple of pipes like this last jpg should work and be completely
fail safe. The frontal area is low so the drag may be lower than it looks.
http://www.ewha.co.kr/company/eng1.htm
The ultimate solution is recover all this waste energy in the exhaust with a
turbo compound set up. Exhaust driven turbines do a good job of quieting the
exhaust. Turbo charged rotaries need no mufflers.
Paul Lamar
I might ad to those pics, each of those outlets are2" but the exhaust relief
hole is only 1" inside each one. It sounds pretty good....for a rotary....
http://www.youtube.com/watch?v=e5JWi5yyj1A
Bob
You should make a bunch of fish tails instead of the small holes.
That is what the Merlin had. You get a bit of thrust out of the fish
tails.
There is a BIT of wind noise in the mike. Understandable from the
time I lived in Midland :)
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.