Has anybody found a source for full size carbon fiber
prop spinners? I would like to have an 18 inch.
I have a metal version that could be used as a mold.
Paul Lamar
Paul,
I worked for Angel Aircraft Corporation (AAC) for a few years and helped
Carl Mortenson certify the Angel. We tried fiberglass spinners, however,
they would not hold up under the centripetal loads at 200% RPM for 5
minutes. The fiberglass spinner made 200% rpm for about 4 minutes before
flying apart in the plane of rotation. So we had to go with carbon fiber
spinners. They are very large spinners as you can see in the pictures:
http://www.angelaircraft.com/images/New_Gallery.htm
Here is another URL regarding AAC:
http://en.wikipedia.org/wiki/AAC_Angel
This was twenty years ago, and I do not know if they are using the same
vendor for the spinners or not. I am sure Carl or Ed Mortenson would be
willing to tell you who they use now.
Call them at (712) 737 - 3344
The vendor back then was called Texas Composites. I cannot find a Texas
Composites, however, there is a company called Texas Air Composites. Maybe
they are the same company.
Here is a URL for Texas Air Composites:
http://www.texasaircomposites.com/operations.html
If you are flying your plane to OSH this year, lots of pilots stop at ORC
going to or coming back from OSH, so it must be a good stopping place for
fuel. I am sure the folks at Angel Aircraft would be happy to show you
around. I personally think they need to use a three rotor instead of their
IO540's, however, it would have to be certified.
Regards to all,
Norm DeBoer
Thanks guys.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.