We are having a rotary mini fly in / drive in /party today at SZP
at Hangar
6 on the Vicki Cruze taxiway.
Lunch at Logsden at 1 PM maybe or perhaps take out if not enough
time to get
the wings on the RV4.
Weather forecast is excellent.
Sorry about the short notice.
Paul Lamar
Wings are on. Thanks to Dave Leonard that flew in from
Oceanside and local Steve wing holder/wiggler extraordinar.
Dave, we found the upper rear tie plate.
Paul Lamar
--
Thats great that you found the stich plate. Now Robin can spend some
daily Zen time and get a few more bolts each day. That I think is the
key to getting stuff done. One LITTLE project each day.. ok then
another little project after that if you still have the energy.
let me know when you are ready for me to come up for another day of
little projects.
I have been thinking about the timed injection issue you mention. I
think you said that there would only be 3 mS, but I calculate 8.5mS at
7000RPM. That leaves 6.8ms at an 80% duty cycle. With 2injectors/rotor
that should be plenty if they are properly sized. Did I miss something?
I have had mine to 7100 RPM and it runs fine.
Here is another data point. If I am running on only a SINGLE set of
injectors, right around 6000 RPM and 28 MAP my tachometer drops off to
zero (engine still running fine). That tells me that they are not being
turned off long enough for the tach to detect.. approaching 100% duty.
My primaries are th 45cc (something like that - the n.a second gen
version) stock injectors. I installed those a while back instead of
the 52? cc (the turbo second gen version) in an attempt to improve
idle. (It didn't seem to do a lot to improve idle - though idle did
improve when Tracy later addressed a slower-than-expected injector coil
decay). Mike DID get that upgrade to his EC2 as well. So you should be
pretty good to go.
--
David Leonard
Turbo Rotary RV-6 N4VY
http://N4VY.RotaryRoster.net
http://RotaryRoster.net
You are correct on the 8.5 ms. Some of the later skinny injectors
(and I think the RX8 injectors are in this category) have a faster
response time. Older injectors can take up to 2.5 ms to turn on.
Here are some numbers on the Siemons. Turn on
time is 1.14 ms. To have them turn off longer increase the
fuel pressure. Same amount of fuel with a shorter duty cycle.
I spent the day moving things around so I would have room for the
wing tips :)
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.