Subject: V8 powered fatal aircraft crash
From: Rotary Engine
Date: 5/28/2011, 11:06 PM
To: AAA Put this in the To box


14 CFR Part 91: General Aviation
Accident occurred Saturday, May 07, 2011 in Conroe, TX
Aircraft: WOODWARD HAROLD L RAVIN 500, registration: N913RA
Injuries: 2 Fatal.

This is preliminary information, subject to change, and may
contain errors.
Any errors in this report will be corrected when the final report
has been
completed.

On May 7, 2011, approximately 0855 central daylight time, a
Woodward Ravin
500 experimental amateur built airplane, N913RA, impacted forested
terrainshortly after takeoff from Lone Star Executive Airport
(CXO), Conroe, Texas.
Visual meteorological conditions prevailed at the time of the
accident. The
personal flight was being conducted under the provisions of 14
Code of
Federal Regulations Part 91. The pilot and student pilot rated
passengerwere fatally injured. The flight was originating at the
time of the accident
and was en route to Temple, Texas, for the airplane to be
displayed at an
aviation event.

According to CXO tower personnel, the pilot was cleared to depart
runway 14
with a right turn on course. The airplane departed and as the
pilot began
his initial right turn he reported smoke in the cockpit. The pilot was
cleared to land on any runway and giving the wind as being from
160 degrees
at 8 knots. The airplane was observed to perform an approximate
240 degree
right turn and crossed back over the departure runway before
entering the
left downwind leg for runway 14. While on the downwind leg of the
trafficpattern the airplane was observed flying,
â<80<9Cslowâ<80<9D, wings
level, at an estimated altitude of 700 to 800 feet above the
ground. While
approximately 4,500 feet along the downwind leg the landing gear was
extended. Shortly thereafter, the airplane started a descending
left turn
towards the closer runway 19. The airplane overshot the extended
centerlineto runway 19 and the airplaneâ<80<99s bank angle
increased. The airplane
continued in the descending left turn toward the runway until
approximately300 feet above the ground. At which point the
airplane appeared to
â<80<9Cstallâ<80<9D and impacted into forested terrain. A post
impactfire ensued. Tower personnel reported that during the event
they did not
observe any smoke or flames coming from the airplane until impact.

A pilot rated eyewitness located near the crash site reported
hearing what
he described as an engine that was â<80<9Cscreamingâ<80<9D and
varyingin RPM. When he saw the airplane it was flying
â<80<9Cvery slowâ<80<9D
at an estimated altitude of 300 to 500 feet above the ground. As the
airplane made a high bank angle turn back towards the airport the
witnessobserved the nose and left wing drop before the airplane
went out of sight.
Seconds later he heard it impact trees followed by an explosion.

The airplane came to rest in an upright position about 1,600 feet
out on the
extended center line from the approach end of runway 19. The
measured impact
heading was 200 degrees magnetic.


------------------------------------------------------------
Sounds like they will never know what happened.

I am guessing. One possible scenario is the automotive clutch Bud
used started
slipping causing the smoke and the â??screamingâ?� engine. The
clutch disk
could wear rather rapidly due to normal high torque fluctuations
at high continuous power.

IMHO the TBO on an automotive V8 in aircraft use should be 300 hours.
Any piston engine can develop a crack in the critical parts
leading to
a hand grenade failure without warning. The main purpose of the
TBO is to
magnaflux the critical parts to detect cracks early before the engine
explodes. Through years and millions upon millions of hours of
experienceand detail refinement the TBO on aircraft engines has
increased to 2000 hours.

The TBO on my C182 engine was 1500 hours. By adding another
torsional damper
on the crankshaft the TBO was increased to 2000 hours. However
unlike a piston
engine in a car the aircraft crank and rods are made of the finest
materialpossible. Only the best methods of manufacturing and
finishing are used.

Parts in an automotive V8 are made as cheaply as possible as the
averagerequired power is only about 40 HP despite a 400 HP rating.

We are so lucky the Wankel rotary does not see the same kinds of
reverse loading
on the e-shaft and the rotor that are seen on a piston engine
cranksaft and rods.
Fatigue failures of the e-shaft and rotor are unheard of.


Paul Lamar



It sounds like the pilot might have stopped flying the airplane,
but instead was
trying to save it. My training was that in case of fire, you get
the airplane on
the ground immediately, as you really don't know what's burning. I
can
understand the smoke could have been incapacitating, so that might
have been the
issue, but if it was the clutch burning, it seems unlikely somehow.


Matt-

I agree but people that build airplanes have so much invested in them
(more than money alone) they appear to be reluctant to crash land
straight ahead
as we were all told to do in case of engine failure on take off.
Here is a map
of the area and there does not appear to be many clear fields
other than on
the airport itself. In the case of rotary crashes at least two fatals
were caused by the pilots attempting to turn back. In both cases there
were suitable fields straight ahead. One rotary crash was caused
by engine
seizure after the loss of all oil pressure due to a split cheap
oil cooler and
the other an interruption in the fuel supply due to a poorly designed
fuel plumbing system.

IMHO there is another more subtle factor. One is naturally
reluctant to do a 180
and land downwind on a controled airport or busy airport. We had
an incident
at SZP where a pilot  had an engine failure in a Bonanza and
successfully made
a 180 and landed down wind. He slammed it in so hard on the 2500
foot runway it
bent the spar and broke the motor mounts totaling the airplane but
he was not
hurt. He skillfully ground looped it when it looked like he was
going to
run out of runway at thew other end. I was standing 50 feet from
the point of
impact.

I think people should practice 180's at altitude with the engine at
idle. Just to get a feel of what the airplane will do. Note the loss
of altitude.

Paul Lamar

Training is great but I can tell you from experience that what you train for
and what you want to do are often to very different things. I've had the
pleasure of having 2 serious incidents, the first as a student I was
'along for the ride' and the second I was PIC. In both of these
the "need to save the plane" was huge. Looking back it was
unbelievable but in the moment it was paramount. The first plane
I was part owner [as a student riding through a forced approach]
the second was a Skydive job where the diver hit the H-stab, even
though it wasn't 'my' plane the urge to bring it down in 1 pc
was overpowering [and I had a chute on and could have
jumped w/out anyone questioning my doing so]

I can't imagine what it would feel like in something i'd built.

Fwiw

Jarrett Johnson


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.