-- 
So that might work for the flap handle (with preselect and motion
indicator)
itself? Feedback motion from flap motor position sensor? There are two
remote components to this--one senses flap position at the motor
drive; the
other is the preselect and indicator mechanism.
Marc



Use any servo you wish, just connect a potentiometer to give position
feedback and a simple comparator circuit to control a motor driver.
The attached schematic shows a pot for position selection, a rotary
switch with fixed resistors would also work.

Victor Roberts


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.