Subject: 13b s4 [3rd gen?]
From: Rotary Engine
Date: 5/31/2011, 3:30 AM
To: AAA Put this in the To box


 Hi Paul

 Hope all is well ?

 On stock 13 b s4 on both primary and secondary fuel rails you have
 fuel pressure regulators are both rated the same pressure and will it
 be possible for me to remove both regulators and run a single one
 adjustable regulator on the line that feeds back to the fuel tank ?

 Cheers
 Barend

 Yes. That is what most people do.

 BTW That makes me think somebody should record the fuel pressure
 1000 times a second with a data acq system. There may be something
 going on there we should know about.

 Paul Lamar


 Hi Paul


 I replaced the hp fuel pump with Bosch pump when the vehicle is cold my
 fuel pressure gauge shows 4 bar [60 psi] as soon as the vehicle heats
 up and I
 did around 25 miles the fuel pressure will drop down to 3 bar [45 psi]
 the pump
 becomes noise I'll switch the vehicle off leave it for 10 - 15 min.
 start the vehicle again and the fuel pressure will be back at 4 bar and
 pump will be quite.

 I have removed the fuel tank and flushed the fuel tank ( and fuel
 lines) have two new in line fuel filters have a carter pre-pump pushing
 at 0.5 bar pressure and 275 LPH to the surge tank( 2.5L tank) the surge
 tank is flushed and cleaned the tank remains full at all times.

 Which tells me my low pressure side is fine. The only thing I can think
 off is that there is a concern with the fuel pressure regulators when
 they start working they become hot and can not keep up ?

 Cheers
 Barend.

 Is the new pump in the surge tank? Many in the tank pumps are designed
 to be cooled by the fuel. I have never heard that about fuel pressure
 regulators. One can buy a low cost infra red thermometer that can tell
 the
 temperature of something by merely "looking" at it. The 2.5L surge
 tank fuel will heat up as hot fuel is returned to it by the pressure
 regulators.

 Paul Lamar


 Re low fuel pressure,  there is a very small gauze filter in the inlet
of most Bosch fuel pumps, which does not take much to clogg up but keeps
out bits from the pump
if the pump is noisy when hot i would think it is caviating,
probably due to the hot fuel and a low pressure on the suction side.
John Burey

Hi John


That sounds correct to me as the pump starts to become noise I'll poor
cold water on the surge tank and pump and the noise will go away. Going
to fit fuel cooler and feed back once completed.

Cheers
Barend.
--


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.