Jeff,
 Slowly working my way through this rebuild of my single rotor engine.  Paul says you might be able to modify my Ross drive to accept a thrust bearing.  Can you do that?

 In addition to the drive itself, do you need the bell housing thwt it mounts to?

 How much will it cost, including the required bearings?

 Lewis Bjork,  801 968-3034


Lewis

sure...... I could tackle it with some coaching from Paul.....never done
it before.........can't know what to charge until I talk to Paul..........

jeff

I would charge by the hour as every Ross drive was slightly different.
It depends on how far the sun gear is from the mounting bulkhead and
the sun gear it self. You might have to modify the sun gear slightly
to get room for the thrust bearings.

Paul Lamar