Jeff,
  Slowly working my way through this rebuild of my single rotor
 engine.  Paul says you might be able to modify my Ross drive to accept
 a thrust bearing.  Can you do that?

  In addition to the drive itself, do you need the bell housing thwt it
 mounts to?

  How much will it cost, including the required bearings?

  Lewis Bjork,  801 968-3034


 Lewis

 sure...... I could tackle it with some coaching from Paul.....never done
 it before.........can't know what to charge until I talk to
 Paul..........

 jeff

 I would charge by the hour as every Ross drive was slightly different.
 It depends on how far the sun gear is from the mounting bulkhead and
 the sun gear it self. You might have to modify the sun gear slightly
 to get room for the thrust bearings.

 Paul Lamar


 Paul

 So I would need the entire unit, housing, etc to get clearances....

 I will have him send it, look it over, then quote, $50 hr.......I get a
 lot more than that normally on the cnc...

 thanks

 jeff

 Correct Jeff. When you get it take notes as I want you to build a new
 one (with some improvements) for me from scratch.

 Paul Lamar

Done, Jeff.  Hourly is fine.

I'll send The psru, shaft and bell housing your way.  Anything else?

Lewis.




If you need an address here it is......................1312 Hamilton
lane        Escondido, Ca                92029

jeff doddridge