Jeff,
 Slowly working my way through this rebuild of my single rotor engine.
Paul
 says you might be able to modify my Ross drive to accept a thrust
bearing. Can
 you do that?

 In addition to the drive itself, do you need the bell housing thwt it
mounts to?

 How much will it cost, including the required bearings?

 Lewis Bjork, 801 968-3034


 Lewis

 sure...... I could tackle it with some coaching from Paul.....never done
 it before.........can't know what to charge until I talk to
Paul..........

 jeff

 I would charge by the hour as every Ross drive was slightly different.
 It depends on how far the sun gear is from the mounting bulkhead and
 the sun gear it self. You might have to modify the sun gear slightly
 to get room for the thrust bearings.

 Paul Lamar



PAUL
I JUST ORDER THOSE NEEDLE BEARINGS(2) PLUS 34 WASHER FROM GRAINGER AT
THE COST OF 43.58 PLUS TAX AND SHIPPING TOTAL $46.28


Jean Prudhomme