Subject: Alcohol in auto gas
From: Rotary Engine
Date: 6/19/2011, 5:32 PM
To: AAA Put this in the To box


http://www.enertechlabs.com/fuel_phase_separation_in_ethanol.php
-----------------------------------------------------------------
Courtesy of Scott Irwin

Did you know?  In a 10% Ethanol Blend, it takes as little as 18 gallons of water in a 6,000 gallon tanks to cause Phase Separation. In a 2% blend it takes only 3.6 gallons to cause Phase Separation

What is ?phase separation?, and how do I deal with it?
If significant amounts of water are present in a fuel tank with gasoline that contains ethanol, the water will be drawn into the fuel until the saturation point is reached for the three-component mixture of water + gasoline + ethanol. Beyond this level of water, phase separation could cause most of the ethanol and water to separate from the bulk fuel and drop to the bottom of the tank, leaving gasoline with a significantly reduced level of ethanol in the upper phase. snip Even if the ethanol water phase at the bottom of the tank is not drawn into the fuel inlet, the reduced ethanol level of the fuel reduces the octane rating by as much as 3 octane numbers, which could result in engine problems.

------------------------------------------------------------------------------

This could be a solution to the composite fuel tank problem. Add water to the fuel to combine with the alcohol and keep repeating to remove the alcohol.
Then of course drain the water/alcohol after a period of time.

One could drain the fuel into a storage container if one were not planning on flying anytime soon. It takes time for the alcohol to Attucks the resin.

I have not tried it.

However the rotary does not seem to mind a lower octane fuel.

Paul Lamar




-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.