Paul
Ran into a little problem with the thrust bearing setup....the oil seal
is place on the inside of the planetary housing or the outside of the
bell housing...
having to move it to the other side does give any surface for the seal
to ride, not long enough boss on the back side of the sun gear teeth.....
The model here shows what I am talking about....
take a look, this ..
jeff
Just go down a size on the needle bearing OD. Two bearings back to back are over
kill anyway. What you lose in terms of load is more than made up
by higher RPM life rating. It is all about life rating. Use thin thrust washers
everywhere.
You can cut back on the sun gear tooth width. They only need to be the same
width as the planet gears.
Then build a hat section cup that that is recessed if necessary.
JPG 5.
Tracy puts the seal on the other side.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.