Subject: EVINRUDE 50 HP STATOR AND FLYWHEEL
From: Rotary Engine
Date: 7/1/2011, 4:23 PM
To: AAA Put this in the To box



Paul I received the flywheel for for the stator 173-1232 and i did machined to the maximum on the outside diamete and i leave .330" wall thickness so it can be easy adaptable to the spline hub at 6"outside diameter by using rivets same as Tracy.The problem is the inner shaft hub on the flywheel non machinable  very hard temper so i did drilling all around to get it out.I weight the flywheel after cleaned and show about  3 lbs on my bathroom scaleI should receive the stator within a day.The outside diameter of the flywheel can be reinforced with a stainless steel ring or unicarbon fiber machined and balance,or stainless steel angle ring  to fit the o.diaI do have to complete the machining for the flywheel  on a bigger lathe mine is to small regarding the propshaft i can do some of the machining and get the rest finish by machine shop.I am waithing to receive a wood lathe so i can start to built the wood housing pattern for the prop drive.I have an idea to bolt the flywheel behind the Tracy prop flange and have a circular flange on his housing to hold the stator,the stator dimension is 6"o.dia by 4 1/16"i.dia and about 1 3/8"thick at coils location it might fit on Tracy housing it look the right size may be i am wrong so you can check the dimention on his housing with my design i do have to install on the rotary side flywheel (High RPM)The stator charging output is 6 amps.I bought the flywheel for $30.00 and $70.00 for the stator plus shipping on EBay the flywheel is for 50 and 55 hp up to 1975 few mores  availables on EBAY


Jean Prudhomme

                       
EVINRUDE 50 HP STATOR AND FLYWHEEL
http://skydrive.live.com/redir.aspx?cid=83c64c1851927d22&page=browse&resid=83C64C1851927D22!196&type=5&Bpub=SDX.Photos&Bsrc=Photomail&authkey=IiY4ytqj1Xk%24


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.