Subject: EVINRUDE 50 HP STATOR AND FLYWHEEL
From: Rotary Engine
Date: 7/2/2011, 11:45 AM
To: AAA Put this in the To box


   Paul I received the flywheel for for the stator 173-1232 and i did
   machined to the maximum on the outside diameter and i leave .330" wall
   thickness so it can be easy adaptable to the spline hub at 6"outside
   diameter by using rivets same as Tracy.The problem is the inner shaft hub
   on the flywheel non machinable  very hard temper so i did drilling all
   around to get it out.I weight the flywheel after cleaned and show about  3
   lbs on my bathroom scaleI should receive the stator within a day.The
   outside diameter of the flywheel can be reinforced with a stainless steel
   ring or unicarbon fiber machined and balance,or stainless steel angle ring
   to fit the o.diaI do have to complete the machining for the flywheel  on a
   bigger lathe mine is to small regarding the propshaft i can do some of the
   machining and get the rest finish by machine shop.I am waiting to receive
   a wood lathe so i can start to built the wood housing pattern for the prop
   drive.I have an idea to bolt the flywheel behind the Tracy prop flange and
   have a circular flange on his housing to hold the stator,the stator
   dimension is 6"o.dia by 4 1/16"i.dia and about 1 3/8"thick at coils
   location it might fit on Tracy housing it look the right size may be i am
   wrong so you can check the dimension on his housing with my design i do
   have to install on the rotary side flywheel (High RPM)The stator charging
   output is 6 amps.I bought the flywheel for $30.00 and $70.00 for the
   stator plus shipping on EBay the flywheel is for 50 and 55 hp up to 1975
   few mores  availables on EBAY


   Jean Prudhomme

       EVINRUDE 50 HP STATOR AND FLYWHEEL


http://skydrive.live.com/redir.aspx?cid=83c64c1851927d22&page=browse&resid=83C64C1851927D22!196&type=5&Bpub=SDX.Photos&Bsrc=Photomail&authkey=IiY4ytqj1Xk%24



 Jean,
 I have a 14 inch engine lathe with carbide tooling . If we can help, let me
 know,
 Milo


Paul i just received the stator and the weight is 2.5 lbs there is some photos and dimensions if you need mores infos or dimensions let me know


Jean Prudhomme

                        
EVINRUDE 50 HP STATOR AND FLYWHEEL (2)
http://skydrive.live.com/redir.aspx?cid=83c64c1851927d22&page=browse&resid=83C64C1851927D22!208&type=5&Bpub=SDX.Photos&Bsrc=Photomail&authkey=MnAwmWcdlqM%24
-- 

That Evinrude unit looks near perfect for our use. Ignition and alternator all
in one.

Good work Jean.

Paul Lamar


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.