Subject: Polishing aluminum airplanes
From: Rotary Engine
Date: 7/2/2011, 12:02 AM
To: AAA Put this in the To box

I decided to polish the RV4 rather than get it painted.
I have more time than money. I have other uses for
the 7 to 1OK.

Doing it by hand is very very tedious I found out rather
rapidly. I got some white aluminum polish at the auto parts
store that worked well on the shiny alclad. I bought
another brand from Rutland tool but it was the same stuff.
Worked about the same

There were these gray strips on the rivet lines and somebody told me
that was caused by the the plastic protective sheets Van glued to
the Alclad. You stripped it off where the rivets went and the bare
aluminum turned gray on its own over time. That was another problem
entirely. Nothing seemed to work. I tried 320 grit flap wheels which
took it off alright but left microscopic scratches on the aluminum
the white polish had a hard time with. Same for scotch brite. Too
coarse. I then tried 3000 grit sand paper by hand and that worked
only slightly better but was extremely tedious.

I saw a guy on Youtube polish an aluminum diesel truck tank in 20
minutes
or most of it anyway. He used what we used to call a body grinder. I
had
3 HP versions. One that was close to 40 or 50 years old.

He actually used two with buffing wheels. One had one type of polish
and the other another type of polish. I went to Harbor Fright to get
a buffing wheel and they had several different compounds for polishing
aluminum. They had the white which looked like the other two whites
I already had. They also had gray which they called a fast cut
compound.

Bingo! It worked like a charm with the 8 inch spiral sewn buffing
wheel
mounted on the body grinder. In an hour I had half the lines gone on
one side
of the fuselage. Another hour to buff it out. The type of buffing
wheel
is also critical. One needs the spiral sewn. No replacement for
displacement
the 3 HP body grinder is also essential.

Saved myself $7000. Does not make sense to have a $3000 rotary engine
and spend $7000 on a paint job :)


Paul Lamar


Very smart of you to use a buffing wheel.  Doing it by hand would be a
real grind.
jd


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.