Subject: Stator flywheel attached to propshaft
From: Rotary Engine
Date: 7/3/2011, 9:08 AM
To: AAA Put this in the To box

Paul,

Here is a sketch of an idea to attach the stator flywheel to the prop
flange,this can be adaptable to the Tracy housing for the stator i
 guess but i
don't have his dimensions


Jean Prudhomme


Yes that would work as just an alternator if you can find large
 magnets designed
for a 6.5 inch diameter drum. It would not work for ignition as the
 gear ratio
would mess the timing up.

Better to do what you are doing.

Paul Lamar


 Ok i see what you mean.


 Jean Prudhomme


 Here is the complete dual redundant dual back up ignition system.
 Engine still runs if you loose the main alternator and electrical
 system. CD on the leading (Lower) plugs and RX8 style inductive ignition
 on the trailing (Top) plugs.  Basically it is like a solid state mag.
 The low current 5 volts for the  hall effect sensors can be powered by
 the OMC power coils.

 Paul Lamar


Hi  Paul,  I may be barking up the wrong tree, but would it not be
better to install the stator onto the input side of the reduction drive
and the flywheel, whats left, attached to the Rotary flywheel, one would
then have a backup alternator(no drive belt to break or jump off), and a
solidstate ignition system, I have also wondered about having two spark
plugs side by side, obviously Mazda have the plugs in the ideal spot.
John Burey.

Yes. That is exactly what Jean is doing.
Some rotaries have two plugs side by side.

Paul Lamar


Hello  Paul,
I have not seen any rotarys with the two plug idea
but I thought that it would be like having a two plug setup in a piston
engine,(altho that is also good for compustion especially in large bore
engines), but I wondered about the compression loss while the tip ?
seals were passing the plugs, is there a compression loss or is the
chamber not yet under compression? as you know i know nothing about
rotarys. I like the very simple ignition system, you have shown from
Silicon Chip magazine. I usually buy it every month.
John Burey.

Yes there is a compression loss for the trailing (ToP) plug.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.