Paul,

What's the name of the company you get the blue silicone water hoses from?
(reminder)

I cast the spinner you loaned me and pulled a part.  It came out pretty
good, and light.  Now I have to figure out how to make mounting plates for
it.  I was thinking an aluminum disc with a fiberglass ring that mates to
the spinner for the rear but I'm not sure what to do for the front
support.
Any thoughts?

Randy

Contour a bit of foam that fits in the front part of the spinner.
Then lay up disk in there using plastic garbage bag material
wherever you don't want it to stick. Same for the back bulkhead.

You will need two bulkheads straddling the prop.


The relatively low cost silicone rubber hose supplier is:

http://www.siliconeintakes.com/


The constant tension hose clamps can be had from McMaster Carr.

Paul

I did get the blue silicon hoses from McMaster Carr too.

Richard Sohn
N2071U
www.fairpoint.net/~res12/home.html


Great web site Richard. Everybody interested in LSA or one rotor engines
should take a look at Richard's new web site.
www.fairpoint.net/~res12/home.html

Randy has a one rotor as well.


Paul Lamar



Richard
Very good web site, enjoyed reading it.

Are you taking orders, That is just what I'm looking for.

Regards

Keith Bennett