Paul There is some photos of the damper plate with stator flywheel arrangement.I will have to bore on the back side of the middle splines pce to meet the outside diameter of the big mid washer who is  attached to engine flywheel and will be serve as alignment and it will still enough splines length also this mid washer stub can be shorten a bit ,i have to figure out the dept when i do received the full assembly damper of J Smiths.As per your photos you do have some king of Teflon washer between the flywheel and damper plate do i am wrong anyway i will see when i received the damper.I did allow 1/4" of uni carbon fiber lining at the outside diameter of the magnet wheel and the deep of the face of magnet wheel can be shorten at least 1/4" if i need it


Jean Prudhomme

                        
Stator project progress



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.