I decided to polish the RV4 rather than get it painted.
I have more time than money. I have other uses for the 7 to 1OK.
Doing it by hand is very very tedious I found out rather rapidly. I
got some
white aluminum polish at the auto parts store that worked well on
the shiny
alclad. I bought another brand from Rutland tool but it was the same
stuff.
Worked about the same
There were these gray strips on the rivet lines and somebody told me
that
was caused by the the plastic protective sheets Van glued to the
Alclad.
You stripped it off where the rivets went and the bare aluminum
turned gray
on its own over time. That was another problem entirely. Nothing
seemed to
work. I tried 320 grit flap wheels which took it off alright but left
microscopic scratches on the aluminum the white polish had a hard
time with.
Same for scotch brite. Too coarse. I then tried 3000 grit sand paper
by hand
and that worked only slightly better but was extremely tedious.
I saw a guy on Youtube polish an aluminum diesel truck tank in 20
minutes or
most of it anyway. He used what we used to call a body grinder. I had
3 HP versions. One that was close to 40 or 50 years old.
He actually used two with buffing wheels. One had one type of polish
and the
other another type of polish. I went to Harbor Fright to get a
buffing wheel
and they had several different compounds for polishing aluminum.
They had
the white which looked like the other two whites I already had. They
also
had gray which they called a fast cut compound.
Bingo! It worked like a charm with the 8 inch spiral sewn buffing
wheel
mounted on the body grinder. In an hour I had half the lines gone on
one
side of the fuselage. Another hour to buff it out. The type of
buffing wheel
is also critical. One needs the spiral sewn. No replacement for
displacement
the 3 HP body grinder is also essential.
Saved myself $7000. Does not make sense to have a $3000 rotary
engine and
spend $7000 on a paint job :)
Paul Lamar
Paul,
Where did you get the smaller of the two buffing machines??? That
could come
in handy with my rotary engine Suzuki RE-5. I'm always looking for
better
buffing tools for my motorcycles...
Dave P
I don't remember where I bought it as it is near 50 years old.
It is a very dangerous product to use and would never make it
past the nanny state. (OSHA) In fact it bit me yesterday.
I just replaced it with an air grinder from Harbor Freight.
http://www.harborfreight.com/air-angle-die-grinder-32046.html
BTW the small buffing wheel shown is no good. It needs to be sewn
(spiral)
all over to make it much stiffer. Take it to a shoe repair place. It
takes at least 5 pounds per square inch surface pressure to polish
aluminum. If you are hand polishing small spots get a 1.5 inch cube
of semi flexible polyethylene closed cell foam. Wrap it in a paper
towel and use that. Replace the paper towel frequently as it starts
to turn black.
Higher surface pressure is the main secret to polishing aluminum.
Finger pressure is not enough. It is why the big grinder works so
well.
http://www.youtube.com/watch?v=gyOodLNI4BQ
Paul Lamar
I see a disk holder but don't see a buffing wheel (in the Harbor
Freight page). Was it in another message?
Al.
I am not sure the buffing wheel is on the HF web site .
What you are doing is adapting a buffing wheel to a disk
sander so it is rather tricky.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.