Not counting the time to make this rig.
You will need a hose barb fitting that screws into
the top of the brake fluid res. for the over flow
tube. Another one in the bottom of the brake fluid container.
I made this rig out of stuff I could buy in the
local hardware store. 2 inch pipe and a reducer.
A plastic plug for the brake fluid container.
The reason it is near the roof of the hangar is to increase
the pressure.
Dave and Doug witnessed this miracle after Dave found a defective
bleed fitting.
Air bubbles want to go up so feeding the fluid in from the
bottom is the best way as the brake caliber is always the lowest
device, The master cylinder is next up and then the
brake fuild res where you want the air bubbles to go.
Paul Lamar
Paul, It seems common here in Australia to use a little pump type
oil can, dedicated to aircraft brake fluid, after the style of old steam
train oilers, connect a plastic tube to the bleeder and fill the system
from the bottom, no air in system=-O .
John Burey
That sounds like that will work great.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.